Step 1 - Open film door and locate the small sliver button. (If you do not remove film you will not expose any film, if you do remove it you will only expose the first one so you just pull it out).
Step 2 - Push in the small sliver button.
Step 3 - If light goes out, take rollers out and clean them and put them back in then clean around the silver button, or just take the rollers out and put them back in. Rollers just man not be in properly.
Step 4 - Then try to pull film again.
Step 5 - If light goes out you fixed it.
Step 6 - If light does not go out when you pull film call your service tech. You may need new set of rollers.
If light does not go out in step 3, call your service tech you have a defective switch.
|
View Cart
View Cart
Banner Stands
